Water Damage Restoration – What Exactly Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the home could be due to an overflow, flood or any other water damage and mold event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. There are 2 large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) as well as the RIA (Restoration Industry Association) that recommends standards for water damage restoration. The S500 damage because of water guide is the benchmark tool that is utilized by companies specializing in restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the first and the most significant part of water damage and mold restoration. The assessment must be correct in order that the right response can be used. In restorating the harm due to water, technicians and the insurance companies must work together and know very well what is damaged and the way to restoring the injury. Identifying the source of the damage, documentation of damage, and accurate estimates are mandatory for a proper water damage restoration. Categorization is based on the contamination amounts of the water source. The categories are highlighted below
Category 1 – This can be water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This really is water which has some contaminants like water from a dishwasher, washer or toilet with urine.
Category 3 – This really is water that is certainly highly unsanitary and can do causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are some examples.
Decontamination and Drying – After the evaluation is finished, the whole process of drying and decontaminating begins at the site. Based on the extent of damage, damage caused because of water can be classified into 4 types. Class 1 Damage- When loss is fixed to your small area and fewer water has been absorbed by materials. This brings about slow evaporation rate. Class 2 Damage – When the damage would be to the whole room and carpet area. Class 3 Damage – If the entire area is saturated with water and Class 4 Damage – when there are lots of deep saturation pockets. Decontamination and drying is a key stage in Water damage restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments must be used. Decontamination has to be done if contamination has been detected in the area. Decontamination may be completed for the whole area or even in specific pockets where contamination has been detected.
Monitoring and Completion – Monitoring the restoration procedure for damage caused because of damage is essential to achieve the desired results. One must be proactive through the monitoring process. Checking in the event the drying devices are setup properly, assessing if the personnel involved are qualified for the job and checking if the equipments have been in working order inwtsy all part of the monitoring process. Necessary steps should be taken if something wrong is spotted during the monitoring process. The complete process of water damage restoration would be considered complete just once the humidity, temperature as well as the moisture content is just as per industry standards. Upon completing this type of water damage restoration process, the drying equipment can be removed.